KitchenAid dishwasher Clean light blinking
KitchenAid describes a two-part Clean-light pattern. Count the flashes up to the short pause as the F number. Count the next group as the E number. The longer pause marks the end of the code.
Send your request. WAVE will call to confirm a time.
Where does one Clean-light code end and the next repeat begin?
For example, seven flashes, a short pause and one flash would be written F7E1. This example explains how to transcribe the pattern. The model determines the applicable fault guide. Record one full repetition and tell WAVE whether water was still in the tub when washing stopped.
What if I counted the flashes incorrectly?
Send a recording of the repeating pattern if you have it. Tell WAVE whether the Clean light was blinking alone or alongside another indicator.
KitchenAid owner support: flashing Clean light.
KitchenAid appliance error codes.
Questions before you book
What if I counted the flashes incorrectly?
Send a recording of the repeating pattern if you have it. Tell WAVE whether the Clean light was blinking alone or alongside another indicator.
A count explains the code, while the stopped wash tells service when it happened. A light that began blinking before any water entered is useful evidence even if the tub is now empty.
At what point did the Clean light begin blinking?
After noting the two flash groups, record whether detergent was still in its cup, whether the dishes were wet, and whether water remained over the filter. Use the clues left by the previous cycle without restarting it to produce another recording.
Related services and guides
References: KitchenAid owner support: flashing Clean light.
